March 10th, 2010

Introduction goes here

Dynamometer Summary


Dynamometer Test

   

Test Parameters

Location: Wegner Motorsports (Markesan, Wisconsin)
Break-in: Approximately 20 minutes using standard mineral base motor oil
  After break-in, the motor oil in engine A was replaced with Demson's Everoil; the motor oil in engine B was replaced with a NASCAR recommended motor oil.
   
Session 1: Approximately 1 1/2 hours at 80% load with sweeps every 15 minutes.
Session 2: Approximately 1 1/2 hours at 100% load with sweeps every 15 minutes.
   
End: Engines were disassemble and components were checked for wear.
   

Engine A

Motor oil: Demson's Everoil
Engine Manufacturer: General Motors
Cubic inch: 350
Stated horsepower: 250 HP
Actual horsepower after break-in: 266 HP
Actual horsepower after test: 287 HP

   

Engine B

Motor oil: NASCAR Recommended Motor Oil
Engine Manufacturer: General Motors
Cubic inch: 350
Stated horsepower: 250 HP
Actual horsepower after break-in: 265 HP
Actual horsepower after test: 266 HP